あなたは歯科・医療関係者ですか?

WHITE CROSSは、歯科・医療現場で働く方を対象に、良質な歯科医療情報の提供を目的とした会員制サイトです。

日本語AIでPubMedを検索

日本語AIでPubMedを検索

PubMedの提供する医学論文データベースを日本語で検索できます。AI(Deep Learning)を活用した機械翻訳エンジンにより、精度高く日本語へ翻訳された論文をご参照いただけます。
J Adhes Dent.2017;19(2):169-176.

正常および人工的に侵食された象牙質に対するセルフエッチングアドヒーシブの長期接着強さ:相対湿度および唾液汚染の影響

Long-Term Bond Strength of Self-Etch Adhesives to Normal and Artificially Eroded Dentin: Effect of Relative Humidity and Saliva Contamination.

PMID: 28439578

抄録

目的:

正常象牙質および人工的に侵食した象牙質に対する2種類のセルフエッチングアドヒーシブの短期および長期の接着強さに及ぼす相対湿度と唾液汚染の影響を調べること。

PURPOSE: To investigate the effect of relative humidity and saliva contamination on short- and long-term bond strength of two self-etch adhesives to normal and artificially eroded dentin.

材料と方法:

抜去したヒト臼歯から合計480個の象牙質標本を作製した。半数(n=240)は無処置(正常象牙質)とし、残り半数(n=240)は人工的に侵食した象牙質とした。試験片は、クリアフィルSEボンド(CSE)またはスコッチボンドユニバーサル(SBU)で処理し、コンポジットレジン(フィルテックZ250)を、ヒト唾液汚染のない/ない相対湿度45%または85%の4つの実験条件下で処理象牙質表面に塗布した。24時間(湿度100%;37℃)または1年間(水道水;37℃)保存後、せん断接着強さ(SBS)を測定した。SBSの結果は、ノンパラメトリックANOVAとWilcoxon-Mann-Whitney検定(有意水準:α=0.05)を用いて統計的に分析した。

MATERIALS AND METHODS: A total of 480 dentin specimens were produced from extracted human molars. Half of the specimens (n = 240) were left untreated (normal dentin) whereas the other half (n = 240) were artificially eroded. The specimens were treated with Clearfil SE Bond (CSE) or Scotchbond Universal (SBU), and composite (Filtek Z250) was applied to the treated dentin surface under four experimental conditions: at a relative humidity of 45% or 85% without/with human saliva contamination. Shear bond strength (SBS) was measured after storage for 24 h (100% humidity; 37°C) or 1 year (tap water; 37°C). SBS results were statistically analyzed with a nonparametric ANOVA followed by Wilcoxon-Mann-Whitney tests (significance level: α = 0.05).

結果:

SBSは、象牙質基質(正常象牙質または人工的に侵食された象牙質)および接着剤に有意に影響されたが(p<0.001)、相対湿度、唾液汚染、保存には影響されなかった。SBSは、順位(MPa;中央値[プール])に従って有意に異なった(すべてp<0.001):正常象牙質上のSBU(21.1)>正常象牙質上のCSE(19.2)>人工的に侵食された象牙質上のSBU(17.1)>人工的に侵食された象牙質上のCSE(10.9)。

RESULTS: SBS was significantly influenced by the dentin substrate (normal or artificially eroded dentin) and adhesive (p < 0.001) but not by relative humidity, saliva contamination, or storage. SBS significantly differed (all p < 0.001) following the ranking (MPa; medians [pooled]): SBU on normal dentin (21.1) > CSE on normal dentin (19.2) > SBU on artificially eroded dentin (17.1) > CSE on artificially eroded dentin (10.9).

結論:

正常象牙質では,2種のセルフエッチ接着剤は,高湿度や唾液汚染などの悪条件下でも経時的に安定した接着強さを示した.しかし、侵食により変化した象牙質では、調査した両接着剤の接着強さに有害な影響を与えた。

CONCLUSION: On normal dentin, the two self-etch adhesives showed stable bond strength over time even under adverse conditions such as high relative humidity and saliva contamination. However, erosively altered dentin had a detrimental effect on the bond strength of both the adhesives investigated.